Page 1 of 1

ROM PAC replica boards

Posted: Mon Mar 11, 2024 6:53 am
by Abzman
Well, I did it. I finally wrote this up. It was a bit of a journey going down all those tangents. I don't have any spares right now and I'm not making more until I get the darn thing working as a RAM PAC. I think that's just a problem with my sorcerer 1 and its many mods. I tried it on a friend's sorcerer 2, but it may not have had the jumper set for writing to the cart slot.

https://abzman2k.wordpress.com/2024/03/ ... c-replica/

Re: ROM PAC replica boards

Posted: Mon Mar 11, 2024 11:38 am
by johnhalk
Wow. Excellent work. I am sure it needs a sorcerer 2 with the motherboard mod for rampac.

This would be great for sysgen of a 56k Dreamdisk CP/M system instead of the 48k standard one.

Regards,
John Halk

Re: ROM PAC replica boards

Posted: Mon Mar 11, 2024 12:02 pm
by Abzman
I'll get my sorcerer 1 updated to sorcerer 2 levels eventually, but all the different period correct mods/fixes/TSBs has been confusing. I actually got it up to 48K internal with SRAM making up the 16K difference, I just don't think I did the ROMRD15 mod to make that a generic read/write signal.

Re: ROM PAC replica boards

Posted: Thu Feb 27, 2025 4:25 am
by zenxyzzy
I've fabbed 10 of the rompac's, and built and printed 3d models of the rompac.

i wrote it in openscad, so it's easy to modify.

the repo for the rompac is https://github.com/cm68/exidy-rompac

I'll post a real picture of the assembled beast once the latest one comes off the printer.

i've also put it on thingyverse: https://www.thingiverse.com/thing:6963005
large_display_rompac.png
large_display_rompac.png (48.13 KiB) Viewed 66344 times

Re: ROM PAC replica boards

Posted: Mon Mar 03, 2025 8:54 pm
by Abzman
Fantastic, I'll link the 3d models in the original post if you don't mind.

Re: ROM PAC replica boards

Posted: Tue Mar 25, 2025 2:50 am
by zenxyzzy
i've tuned it a lot since the original design. it clamps the original rompac board really well, and the new ones are mechanically identical.